Welcome to Würth Australia For trade customers only

ABN customers only

Toll free 1300 65 77 65

Purchase on account

400+ Sales Representatives

More than 11,500 products

Plastic adhesive REPLAST® Easy Fast

Adhesive for plastics

Art.-no. 08935003

Prices for customers after login

Plastic adhesive REPLAST® Easy Fast

Art.-no. 08935003

Prices for customers after login



Exclusively for trade customers

Register now and access more than 11,500 products

For REPLAST® Easy plastic repair system

An adhesive for virtually every type of plastic

  • No need for inconvenient use of different types of adhesive

  • Can be used for repairs and structural bonding

Special positive mixer

  • Optimum mixing with minimum volumes

  • Low adhesive loss (waste)

Quick to harden

Further work, such as sanding, is possible within an extremely short period of time

Excellent chemical resistance

Resistant to a wide range of liquids, such as petrol, many lubricating oils and ethyl acetate



There may be adhesion problems in individual cases due to the coatings and release agents used in some cases in the plastic production process. Not suitable for PE (polyethylene), PP (polypropylene) or PTFE (polytetrafluor ethylene) plastics. Check material compatibility on an invisible area if necessary.

The usage instructions are recommendations based on the tests we have conducted and on our experience; carry out your own tests before each application. We do not assume any liability for a specific application result due to the large number of applications and storage/processing conditions. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and carry out further development.

Product information

Wurth Catalogue(X)

Catalogue page as PDF 1  |  2  |  3

Flip catalog

Application area


Spoilers, radiator grills, panel clips, bumpers, brackets on headlights and radiators etc.

HGVs and buses:

Aprons, bumpers, air intake pipes, wheel arches etc.


All panelling


50 ml

Chemical basis

Two-component polyurethane

Processing time

1.5 min



Can be sanded after

10 min


1.225 g/cm³

Min. initial strength

10 min

Min. skin-formation time

5 min

Min./max. processing temperature

15 to 25 °C

Min./max. temperature resistance

-30 to 100 °C

Shore D hardness




Suitable glove:

Nitrile chemical protective glove
Nitrile chemical protective glove
Permeation level: 2
Cotton velour lining
Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.
Measured breakthrough time
Permeation level
< 10 min
≥ 10 min
≥ 30 min
≥ 60 min
≥ 120 min
≥ 240 min
≥ 480 min

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.