Welcome to Würth Australia

More than 20,000 products

All major credit cards accepted

450+ Sales Representatives

Toll free 1300 65 77 65

REPLAST Plastic primer

REPLAST plastic primer
REPSYS-PLA-PRIMER-200ML
REPLAST

Art.-no. 08935002
EAN 4045989429240

Prices for customers after login

Exclusively for registered customers

Register now and access more than 20,000 products

Adhesive primer for most common plastics

The plastic primer improves the adhesion of REPLAST plastic adhesives on various plastic surfaces.

Notice

Carry out preliminary tests to ensure surface compatibility.

The usage instructions are recommendations based on the tests we have conducted and on our experience; we advise conducting your own tests before each application. Due to the wide range of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no liability is assumed in relation to the provision of this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting in bad faith. We guarantee the consistent quality of our products. We reserve the right to make technical changes and further enhance products.

Product information

Datasheets(X)

Safety data sheet

Certificates/ Documents

 | 

 | 

Application area

The plastic primer improves the adhesion of REPLAST plastic glue to various plastic surfaces.

Instructions

Shake well before use. Spray a thin layer of primer onto the prepared parts from a distance of approx. 30 cm and allow them to flash off for at least 5 minutes at 23°C before beginning gluing. Hold the aerosol can in a vertical position. For more information, please refer to the technical data sheet.

Contents

200 ml

Suitable glove:
 
Product
Description
Nitrile chemical protective glove With cotton velour finish inside
Nitrile chemical protective glove With cotton velour finish inside
Description:
Permeation level: 1
Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.
Measured breakthrough time
Permeation level
< 10 min
0
≥ 10 min
1
≥ 30 min
2
≥ 60 min
3
≥ 120 min
4
≥ 240 min
5
≥ 480 min
6

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.

Art.-no.
Cust. Mat. No.

Hazardous Material

Product information

Datasheets()

Datasheets ()

CAD data  | 

Certificates/ Documents

 | 

 | 

Technical information